If you approach them with care and try to speak their language, they are usually willing to help you getting a jump server setup with the correct software and then you would be able to connect through that.įor smaller plants that might not have a organised IT infrastructure, I have used the 'SiteManagers' from Secomea, which I think is what you are looking for. Usually larger plants and organisations have their own IT department, who already have VPN software setup for a jump station. Firewalls, antivirus were temporary disabled while i did tests.Teamviewer works as a single connection between 2 computers, so there are not really a good way to avoid an 'Engineering workstation' or jump server on the plant. I can also ping succesfully from the remote pc_1 to the remote pc_2, but when i try to ping from local pc to remote pc_2 - all packets are lost.

Minimum = 107ms, Maximum = 238ms, Average = 144ms Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),Īpproximate round trip times in milli-seconds: Now from the local pc i can ping to the address 192.168.2.100: Network Destination Netmask Gateway Interface Metricġ92.168.6.0 255.255.255.0 (remote vpn ip) (local vpn ip) 56 Route was added successfully, i have route in the route table: Route add 192.168.2.0 MASK 255.255.255.0 (ip of the teamviewer vpn of the remote pc) On the local pc i have added a route to the route table: I have installed teamviewer on local pc and remote pc_1 and a vpn adapters of the teamviewer and established vpn connection betwean local pc and remote pc_1. Windows ip configuration shows as follow: On the local pc and remote pc_1 i have enabled routing in the registry. I would like to access remote pc_2 via remote pc_1. Route to the remote station with win route table

Teamviewer vpn not working windows 10